Blog Detail

All about News, Computer and Technology

All about News, Computer and Technology

http://asterix-tech.blogspot.com/

All about Cisco, Router, GNS3 and Networking Stuffs

subscribe Recent Posts

  • Cisco binary image unpacker

    Posted on Tuesday November 3rd, 2009 at 04:46 in gns3

    Cisco binary image unpacker is a software that allows you to unpack the IOS and ASA images. Follow this steps to use this software for GNS3. With this way the Router loading process can be faster. This is useful for those of you that do start and sto...

  • Configuring a Stub Area and a Totally Stubby Area

    Posted on Sunday November 1st, 2009 at 21:53 in ospf, gns3 labs, ccnp labs

    Routers Used: 3640 w/ NM-4TIOS: c3640-jk9s-mz.124-16aObjectiveIn this lab, an OSPF stub area and a totally stubby area will be configured.ScenarioThe Semarang router needs to be upgraded as it is suspected that the router is not keeping up with the g...

  • Configuring Point-to-Multipoint OSPF Over Frame Relay

    Posted on Tuesday October 27th, 2009 at 22:56 in ospf, frame relay, gns3 labs, ccnp labs

    Routers Used: 3640 w/ NM-4TIOS: c3640-jk9s-mz.124-16aObjective In this lab, configure OSPF as a point-to-multipoint network type so that it operates efficiently over a hub-and-spoke Frame Relay topology.Scenario International Travel Agency has just c...

  • Configuring Multiarea OSPF

    Posted on Thursday August 13th, 2009 at 04:53 in ospf, gns3 labs, ccna labs

    Routers Used: 3640 w/ NM-1FE-TXIOS: c3640-jk9s-mz.124-16aObjective In this lab configure a multiarea OSPF operation, interarea summarization, external routesummarization, and default routing.ScenarioInternational Travel Agency (ITA) maintains a compl...

  • Examining the DR/BDR Election Process

    Posted on Wednesday August 12th, 2009 at 22:54 in ospf, gns3 labs, ccnp labs

    Routers Used: 3640 w/ NM-1FE-TXIOS: c3640-jk9s-mz.124-16aObjective:In this lab, observe the OSPF DR and BDR election processing using debug commands. Then assign each OSPF interface a priority value to force the election of a specific router as a DR....

  • Configuring OSPF

    Posted on Wednesday June 10th, 2009 at 22:18 in ospf, gns3 labs, ccnp labs

    Routers Used: 3640 w/ NM-1FE-TXIOS: c3640-jk9s-mz.124-16aObjectiveIn this lab, OSPF will be configured on three Cisco routers. First, configure loopback interfaces to provide stable OSPF Router IDs. Then configure the OSPF process and enable OSPF on ...

Comments & Reviews

There is no rating for this blog because there are no comments yet.

Post A Comment/Review

* Your IP is being logged.
* Your e-mail address is used only for verification purposes only and will not be sold, or shown publicly.
* No HTML tags allowed
* DO NOT use the Comments/Reviews to promote your own site.

Name: or Login
E-mail:
Rating:
Verify: Spam Protection: sum of 1 + 2
Comment:
  Remember Information